Deleting Transmitters - Becker Centronic VarioControl VC470 Notice De Montage Et D'utilisation

a) Deleting transmitters individually
Note
The master transmitter programmed under "programming the radio
control" cannot be deleted. It can only be overwritten (see "overwrit-
ing master").
1. Press the programming button on the master transmitter for 3 seconds.
The curtain will "nod" to confirm.
2. Now press the programming button of the transmitter to be deleted for 3 sec-
onds.
The curtain will "nod" to confirm.
3. Then press the programming button of the transmitter to be deleted for a
further 10 seconds.
The curtain will "nod" to confirm.
The transmitter has been deleted from the VC470.
b) Deleting all transmitters (except master transmitter)
1. Press the programming button on the master transmitter for 3 seconds.
The curtain will "nod" to confirm.
2. Press the programming button on the master transmitter for a further 3 sec-
onds.
The curtain will "nod" to confirm.
3. Press the programming button on the master transmitter for a further 10 sec-
onds.
The curtain will "nod" to confirm.
All transmitters (except master transmitter) have been deleted from the receiver.

Deleting transmitters

de
en
fr
nl
25