Deleting Transmitters - Becker VarioControl VC320 Notice De Montage Et D'utilisation

Assembly and Operating Instructions
4) Deleting transmitters
4a) Deleting transmitters individually
Note
The master transmitter which was programmed in point 1a) cannot be
deleted. It can only be overwritten (see Point 5).
1. Press the programming button on the master transmitter for 3 seconds.
The shutter will "nod" to confirm.
2. Now press the programming button of the transmitter to be deleted for 3 sec-
onds.
The shutter will "nod" to confirm.
3. Then press the programming button of the transmitter to be deleted for a
further 10 seconds.
The shutter will "nod" to confirm.
The transmitter has been deleted from the VC320.
4b) Deleting all transmitters (except master transmitter)
1. Press the programming button on the master transmitter for 3 seconds.
The shutter will "nod" to confirm.
2. Press the programming button on the master transmitter for a further 3 sec-
onds.
The shutter will "nod" to confirm.
3. Press the programming button on the master transmitter for a further 10 sec-
onds.
The shutter will "nod" to confirm.
All transmitters (except master transmitter) have been deleted from the receiver.
28