Deleting Transmitters - Becker Centronic VarioControl VC220h Notice De Montage Et D'utilisation

3) Deleting Transmitters
Note
The master transmitter programmed under 1) cannot be deleted. It is
only possible to overwrite the master transmitter (see point 4)
Deleting all the transmitters (except the master transmitter)
1. Press the programming button of the master transmitter for 3 seconds.
Confirmation occurs via optical feedback.
2. Now once again press the programming button of the master transmitter for
3 seconds.
Confirmation occurs via optical feedback.
3. Subsequently press the programming button of the master transmitter for 10
seconds.
Confirmation occurs via optical feedback.
All the transmitters (except the master transmitter) have been deleted.
4) Overwriting the Master
1. Switch off the power supply to the VC220h and switch it on again after 10
seconds.
The VC220h goes into programming mode for 3 minutes.
Note
To ensure that the new master transmitter is only programmed into the
desired VC220h, you have to remove all the other receivers which are
connected to the same power supply from the programming mode.
To achieve this, carry out a dimming command with the transmitter of
these receivers after reconnecting the voltage supply.
To do so, after switching the power back on, execute a switching com-
mand using the transmitter for the given receivers.
2. Now press the programming button of the new master transmitter for 10 sec-
onds.
Confirmation occurs via optical feedback.
The new master transmitter has been programmed and the old mater transmit-
ter has been deleted.
de
en
fr
nl
17