Intended Use; Assembly - Becker Centronic VarioControl VC470-II Notice De Montage Et D'utilisation

The radio receiver described by the present instructions must only be used for
the operation of awning and blind control units.
• Please note that radio-controlled systems may not be used in areas with
a high risk of interference (e.g. hospitals, airports).
• The remote control is intended solely for use with equipment and sys-
tems in which malfunctions in the transmitter or receiver would not pose
any risk to persons, animals or property, or which contain safety devices
to eliminate such risks.
• The operator is not protected from interference from other telecommu-
nications systems and terminal equipment (e.g. even from radio-con-
trolled systems which are properly operated in the same frequency
range).
• Only connect radio receivers to devices and systems approved by the
manufacturer.
•
Ensure that the control unit is not installed or operated
close to metal surfaces or magnetic fields.
•
Radio-controlled systems transmitting on the same fre-
quency may cause reception interference.
• Note that the range of the radio signal is limited by legis-
lation as well as by design.
Caution
Always ensure when mounting that the cables cannot be
damaged when operating the system. Cover any sharp edges
over which the cable runs with appropriate protective tape. If
the cable is damaged, it may only be replaced by the manu-
facturer.
The radio receiver can be installed in or on the head rail of a sun protection
system, for example.

Intended use

Assembly

21 - en