Checking That The Running Direction Is Correct; Switching Between Venetian Blind And Awning Operation - Becker Centronic VarioControl VC470-II Notice De Montage Et D'utilisation

Checking that the running direction is
Press the UP or DOWN button on the transmitter.
The shading solution runs in the desired direction => The running direction is
OK.
If the shading solution runs in the wrong direction, the running direction must
be switched.
Proceed as follows:
1. Disconnect the mains plug.
2. Turn the direction switch to the opposite position carefully towards the
stop.
3. The running direction will now have changed.
4. Check the running direction again.
Switching between venetian blind and
Press the programming button on the master transmitter for 3 seconds until
the receiver confirms.
Then press the programming button and also the Up/Stop/Down buttons for
10 seconds until the receiver confirms.
The switching process is now complete.
correct
Direction switch
awning operation
25 - en