Publicité
Les langues disponibles
Les langues disponibles
GB
F
D
E
MAINTENANCE
NOTE: Before removing the old blades, take notice of
the direction of cut as well as how the tapered edge of
the old blades are oriented. The tapered edge of the
new blades must be in the same orientation as the
original blades.
Push the blade (to the right) out of the blade holder
using the tip of a screwdriver.
Remove the old blade from the blade holder.
NOTE:If the blade can not be easily pushed out of
blade holder after loosening blade securing screws,
use a block of wood to break the blade loose from
the blade holder, with a short sharp blow. Then push
the blade with a screwdriver to remove. If necessary,
tap the block of wood sharply with a small hammer to
break the blade loose.
Clean any sawdust or wood chips from around the
blade area.
Slide the new blade into the slot of the blade holder.
Use a screwdriver to push the blade into the blade
holder until it is centered into position.
Retighten the two blade securing screws using the
blade wrench.
Repeat the above procedure to change the other
blade.
Clamping screws must be tighten strongly
WARNING
Alignment of blade was preset. Adjustment on
the blade is not allowed.
I
P
NL
S
DK
N
FIN
GR
H
English
REPLACING THE BELT (Fig.14 & 15)
When replacing the belt, use the recommended
replacement belt only.
Remove battery pack from tool.
Remove belt cover screws.
Remove the belt cover.
Force the old belt from the small pulley by turning
in the direction shown. As you turn the belt, pull and
work it off the small pulley until it has been completely
removed from both pulleys.
Install the new belt over the large pulley. As you turn
the belt, push and work it onto the small pulley until it
is in place.
Replace the belt cover.
Install belt cover screws and tighten securely, but do
not overtighten.
NOTE: Do not overtighten the screws.
ENVIRONMENTAL PROTECTION
Recycle raw materials instead of disposing
as waste.
The machine, accessories and packaging
should be sorted for environmental-friendly
recycling.
13
RO
CZ
RUS
PL
SLO
HR
TR
Publicité
