Ryobi CPL-180M Manuel D'utilisation page 15

GB
F D
FEATURES
Your planer is compact and lightweight. It is equipped
with the following features:
SWITCH
The planer has a conveniently located trigger switch.
LOCK-OFF
The lock-off button locks the trigger switch in the OFF
position when the trigger switch is released.
WARNING
Do not allow familiarity with your planer to make
you careless. Remember that being careless a
fraction of a second is sufficient time to inflict
severe injury.
DEPTH ADJUSTMENT
Adjust the planing depth from 0 to 0.4 mm in 0.1 mm
increments and the last step meet to the maximum depth
0.4 mm.
KICK STAND
Your planer is fitted with an automatic retracting kick
stand to prevent the blade from contacting the workbench
on run down.
The kick stand will automatically retract as it passes over
the edge of the workpiece when you commence planing
operation.
EDGE/REBATE GUIDE
The edge guide included allows you to plane edges and
make rebate cuts.
DUST BAG
The dust bag attaches to the planer and helps keep the
work area free of dust and debris.
OPERATION
WARNING
The power planer should never be connected
to a power supply when you are assembling
parts, making adjustments, cleaning, performing
maintenance or when the tool is not in use.
Disconnecting the tool prevents accidental
starting that could cause serious injury.
TO INSTALL BATTERY PACK (NOT INCLUDED) (FIG. 2)
Place the battery pack on the tool.
E I P NL S DK N FIN GR
English
Make sure the latches on each side of the battery
pack snap into place and the battery pack is secured
on the tool before beginning operation.
TO REMOVE BATTERY PACK (NOT INCLUDED) (FIG. 2)
Depress the latches on the side of battery pack.
Remove the battery pack from the tool.
ATTACHING THE DUST BAG (Fig.1)
Follow these steps to attach the dust bag.
Remove battery pack from tool.
Slide the collar of the dust bag onto the dust port.
NOTE: To remove the dust bag, pull it straight out of
the dust port.
ADJUSTING THE PLANING DEPTH (Fig.3)
Always work from a rough cut to a finish cut. The
approximate setting for rough planing is 0.4 mm.
For finish planing use a setting of approximately 0.4
mm. Make test cuts in scrap wood after each adjustment
to make sure that the planer is removing the desired
amount of wood.
Follow these steps to adjust planing depth.
Remove battery pack from tool.
Turn the depth adjustment knob to the desired setting.
NOTE: To protect the blades during storage,
transporting etc., set the depth adjustment to 0.
STARTING/STOPPING THE PLANER (Fig.4)
Follow these steps to start/stop the planer.
To start the planer—Push the lock-off button and then
depress the trigger switch.
To stop the planer—Release the trigger switch.
PLANING (Fig.5)
Follow these steps to plane.
Clamp the work securely.
Adjust the planing depth. Refer to "Adjusting the
Planing Depth" earlier in this manual.
10
RO
H CZ RUS
WARNING
Batter y products are always in operating
condition. Therefore, the switch should always be
locked when not in use or carrying at your side.
CAUTION:
The dust bag fills quickly. Empty it often to
prevent damage to the product.
HR
PL SLO TR