Maintenance & Troubleshooting; 18 6.2 Service Parts / Parts Subject To Wear; 18 6.3 Changing The Printer Paper; Changing The Cable Assembly - Bosch BAT 131 Notice Originale

6. Maintenance &
Troubleshooting
6.1 Cleaning
The housing and the display of the BAT 131 may only be
cleaned using soft cloths and neutral cleaning agents.
Do not use any abrasive cleaners or coarse workshop
cleaning rags.
6.2 Service Parts / Parts Subject to Wear
Designation
Connecting cable with terminals for the
battery
<)
Printer paper (1 roll)
<)
(Minimum order 5 rolls)
wearing part
<)
6.3 Changing the Printer Paper
i
The integrated printer only uses thermal paper in a
roll with the dimensions 57 mm x 25.9 mm.
1. Unlock the printer door gently but firmly lifting up
on the release lever.
2. Remove the empty paper roll hub.
Fig. 6: Printer view
1 Paper Compartment
2 Paper Sensor
3 Release Lever
3. Place a new roll of paper in the compartment.
4. Pull the paper forward so that it extends past the
serrated edge of the paper slot.
Robert Bosch GmbH
Ordering number
Fig. 7:
1 684 465 625
5. Close the door and make sure the lever locks securely.
1 681 420 028
6.4
1. Identify the circled screw on the back of the tester.
2. Remove the screw.
3. Grasp the housing and firmly pull the cable
assembly from housing.
| BAT 131 | 27
Paper feeds from underneath the roll

Changing The Cable Assembly

1 689 989 131
en
|
2019-03-02