Forming The Internal Battery - Siemens SITRANS FUP101 Mode D'emploi

Table 2- 1
2.2

Forming the Internal Battery

Battery Operation
All portable systems include battery chargers that operate from an AC voltage source. We
strongly recommend that you "form" and charge the battery before operating the system for
the first time.
The Charge Indicator LED
A battery status indicator shows the status of its internal battery and charging circuits. The
indicator LED color switches between red or green based upon the flow meter operation.
Green
Red
Forming the Internal Battery
The flow meter uses an internal, rechargeable battery pack designed for a rapid charge cycle
(NiMH, 12 VDC, 3200mAH). The batteries have to be "formed" to deliver their optimum
operating time, which is approximately 7 hours. This is accomplished by performing a
minimum of two complete discharge/charge cycles.
Note
To remove, replace or dispose of the internal battery pack refer to Maintenance and Service
section in the instruction manual.
FUP1010 IP67 Portable Quick Start
Operating Instructions, 01/2013, CQO:QSG003 Revision 05
Power Cord Codes
Assembly P/N
1015BCA-1
1015BCC-1
1015BCD-1
1015BCJ-1
1015BCK-1
1015BCL-1
LED
Trickle charge in progress
Rapid Charge in progress (flow meter must be off)
2.2 Forming the Internal Battery
POWER CORD
Plug Std.
CEE 7/7
A5 3112
BS 1363
JIS 8303
NEM 5-15P
SEV 1011
Battery Condition
Installation
Rating
10A / 230VAC
10A / 250VAC
5A / 240VAC
12A / 125VAC
10A / 120VAC
10A / 250VAC
9