Changing The Threaded Mandrel (Fig. 3); Environmental Protection; Storage; Repairs - Gesipa FireBird Mode D'emploi

GB

2.8.3 Changing the threaded mandrel (Fig. 3)

• Unscrew nosepiece B.
• Push back slide M as far as it will go.
• Unscrew threaded mandrel A and change.
• Align the surfaces of the hexagon on the screwed-in threaded mandrel 1 with the sur-
faces of the hexagon of the holder.
• Lock the threaded mandrel A by pulling the slide M forward as far as it will go.
• Screw on matching nosepiece B, set threaded mandrel length x (see Point 2.7.1) and
secure nosepiece B with lock nut C to prevent it turning.
2.9

Environmental protection

If batteries need to be replaced, please observe the following:
• Return used GESIPA
• Never discard used batteries into household waste, fire or into water!
Caution!
In all EU countries the relevant national regulations for implementing the EU guideline
shall apply.
• In accordance with the EU Directive 2012/19/EC (WEEE), in Germany, this tool is regis-
tered under the WEEE Reg.-No. DE 45695505. If the tool has an 8-digit serial number it
can be returned free of charge to GESIPA

2.10 Storage

Store the blind rivet nut setting tool in a dry place where there is no danger of frost.
3.

Repairs

Repairs under warranty are carried out by the manufacturer. Repairs outside the warranty pe-
riod should only be carried out by skilled technical personnel. Failure to observe the assembly
and setting procedures and operation by non-skilled personnel may result in serious damage
to the blind rivet nut setting tool. In case of doubt, always send in the blind rivet nut setting tool
to the supplier or to GESIPA
You can find the current spare parts list for your tool online at www.gesipa.com.
20
rechargeable batteries to your dealer or to GESIPA
®
.
®
for correct disposal.
®
for recycling.
®