Technical Specifications; Equipment/Accessories; Commissioning; How To Change A Threaded Mandrel - Gesipa FireFox 2 Mode D'emploi

2.4

Technical Specifications

Weight:
Working pressure:
Gun stroke:
Hose connection:
Compressed air
consumption:
Setting force at 5 bar:
Hydraulic oil:
Noise emission Lpa:
Vibration:
Uncertainty:
Compressed air quality:
2.5

Equipment/accessories

Threaded mandrels and,
nose piece:
Tool:
Suspension Loop:
Hydraulic oil:
3.

Commissioning

Prior to operating the Blind rivet nut gun, attach the matching threaded mandrel with nose piece.
3.1

How to change a threaded mandrel

• Disconnect the Blind rivet nut gun from the
compressed air network.
• Detach lock nut 1, using double open-end
spanner SW27.
• Unscrew nose piece 2 with lock nut 1
• Push slide 10 back all the way to buffer and
hold tight
• Unscrew threaded mandrel 3
• Insert new threaded mandrel of same size
(if worn out) or threaded mandrel of
matching thread size all the way to buffer.
3.2

How to set threaded mandrel length "X"

• How to loosen lock nut 1, using a double
open-ended spanner
• Adjust threaded mandrel length "X",
according to nut length (See image 4) by
turning nose piece 2.
16
41303013_Gesipa_FireFox2_160413.indd 16
2,4 kg
5 to 7 bar
max. 10 mm
Ø6 mm (1/4")
c. 2 - 4 litre/setting process (Dependent on nut size)
18,5 kN
ca. 30ml (ISO VG 32 to 46)
75 dB
< 2,5 m/s²
K=1 m/s²
Filtered
dependent on selected gun version,
work position
Hexagon screw driver SW4
2 x double open-end spanner SW24/27
Expandable from device top
1 bottle of hydraulic oil 100ml
1 oil filling container
• Release slide. At the same time make sure
• Insert a matching nose piece for each th-
• Set threaded mandrel length "X", as
• Make full use of depth of thread for closed
• Secure nose piece 2 using lock nut 1
The setting stroke of the Blind rivet nut gun is
not affected by adjusting the mandrel length.
that the threaded mandrel is locked safely
inside the hexagon socket of the slide. If
required, unscrew threaded mandrel
slightly until the slide locks.
read size using lock nut 1 and lock loosely
with locknut, using a double open-ended
spanner.
described under item 3.2.
blind rivet nuts (image 4).
16.04.2013 13:39:32