Threaded Mandrels/Nosepieces; Start-Up; Setting The Threaded Mandrel Length X (Fig. 2); Adjusting The Setting Stroke Y (Fig. 2) - Gesipa FireBird Mode D'emploi

GB
2.6

Threaded mandrels/nosepieces

Thread size
M3
M4
M5
M6
M8
M10
2.7

Start-up

Before starting the riveting tool, read and observe the operating instructions as well as safety
information and keep in a safe place.
• Insert fully charged battery in correct position into the blind rivet nut setting tool.
• Select nosepiece and threaded mandrel from Table 2.6 and screw on (M6 in working
position).
Caution!
The air inlets for the motor must not be obstructed; do not insert any objects into them.

2.7.1 Setting the threaded mandrel length x (Fig. 2)

• Set the threaded mandrel length x to the blind rivet nut length by turning the nosepiece B.
• Fully utilise the thread depth of closed blind rivet nuts (Fig. 2; 4).
• Secure setting of nosepiece B with lock nut C.

2.7.2 Adjusting the setting stroke y (Fig. 2)

• The setting stroke y depends on the size of the blind rivet nut (M3-M10) and of the riveta-
ble material z (Fig. 4).
18
Material
Threaded mandrel
Aluminium
Steel
Stainless steel
Aluminium
Steel
Stainless steel
Aluminium
Steel
Stainless steel
Aluminium
Steel
Stainless steel
Aluminium
Steel
Aluminium
Part No.
Nosepiece
143 5052
143 5055
143 5056
143 5059
143 5063
143 5064
143 5065
143 5066
143 5067
143 5068
143 5069
143 5070