Function Checks; Safe Operation - B.Braun Aesculap ELAN EC GA830 Description Technique Et Mode D'emploi

Switching the device on/off
Risk of injury and material damage due to inadver-
tent activation of the motor!
►
Before switching on, ensure that the pedal of
WARNING
the foot control is not activated.
►
Switch on the device with the "Power On" switch 9.
The illuminated "Power On" indicator light 8 indicates that the device
is ready for operation.
►
Switch off the device with the "Power Off" switch 10.
The "Power On" indicator light 8 goes off.
4.2

Function checks

►
Prior to each use, check that the entire unit is in good working order.
►
Ensure that the device is operated and the parameters are set accord-
ing to the instructions for use and safety information of the accesso-
ries.
►
Carry out a functional check of the accessories according to the corre-
sponding instructions for use.
►
Ensure that all components to be used function properly and are prop-
erly connected.
►
Do not use the product if it is damaged or defective. Set aside the prod-
uct if it is damaged.
►
Switch on the device.
"Power On" indicator light 8 is illuminated.
►
If a micro or mini elliptical shaft is connected: Select left or right rota-
tion.
If left rotation is selected an acoustic signal sounds.
If a macro elliptical shaft is connected, left rotation is blocked and the
motor speed is limited to a maximum of 15,000 rpm.
►
Push the pedal on the foot control down as far as it will go.
The motor starts and reaches the maximum speed in the pre-selected
direction of rotation of the motor.
The corresponding indicator light (12 for left rotation or 11 for right
rotation) illuminates.
The motor audibly runs smoothly and at a constant speed.
►
Only for GA835: Switch on coolant pump 4 via the pump switch on the
foot control.
Pump ON indicator light 3 will be illuminated.
►
Start coolant pump 4 by activating the motor.
►
Control the quantity via the delivery rate control knob 2.
Note
Once the motor has been active for more than two seconds, a special drive
control prevents further coolant from dripping out.
Note
If an error occurs, see Troubleshooting list.
4.3

Safe operation

Risk of injury and/or malfunction!
►
Always carry out a function check prior to using
the product.
WARNING
Risk of injury when using the product beyond the
field of view!
►
Apply the product only under visual control.
WARNING
Activate motor
Note
Follow the instructions for use of the foot control.
To activate right rotation mode:
►
Pre-select right rotation via the foot control.
"Right rotation" indicator light 11 is illuminated.
►
Increase the speed by activating the pedal.
The motor turns in a clockwise direction.
Depending on the activation of the pedal, the speed increases contin-
uously from 0 to the maximum speed.
To activate left rotation mode:
Note
If a macro elliptical shaft is connected, left rotation is blocked. The motor
can only be operated in right rotation mode.
►
Pre-select left rotation via the foot control.
"Left rotation" indicator light 12 is illuminated.
►
Increase the speed by activating the pedal.
The motor turns in a counterclockwise direction.
Depending on the activation of the pedal, the speed increases contin-
uously from 0 to the maximum speed.
The device emits an acoustic signal.
9