Table des Matières
Publicité
EN
S
•
Grease all nipples in all articulations with acid-
free grease. See grease plan in the TECH-
NICAL SUMMARY, or the USER'S MANUAL.
•
Execute all movements several times to ensure all HTL
functions work properly. Pay special attention to:
1. The correct function of the end stops for the lift arms,
and the end stops in the sliding tubes [See § 6.3].
2. The correct alignment of the platform in work position,
flush with the vehicle floor.
3. The loop of the conduit with the electrical wires from
the hydraulic power pack to the control box, when slid-
ing the HTL in / out.
4. The correct position of the platform buffers.
•
Fit all safety markings for the operators and the public
traffic [See Fig. 8.5].
1. For remote controls: mark the safe-working
zone on the vehicle floor and the HTL platform.
See document FIT-ELEC-OPTION-2008-01A.
See www.dhollandia.com for latest version.
2. Fit the platform flags. Check if the flashing
lights work ok.
3. Apply RD/WH reflective marker tape on both
sides of the platform.
4. Apply the instruction stickers near the control
box, in direct sight of the operator.
•
Execute the complete put-into-service test, on the basis of
the CHECKLIST FOR WEIGHT TEST AND COMMIS-
SIONING included in chapter 3 of the user's manual [See
Fig. 8.6].
•
During the weight test, check (and adjust if required) the
hydraulic pressure to suit the nominal lift capacity of the
HTL [See Fig. 8.6]. Seal the pressure relief valve after
that.
DHOLLANDIA
8.5
!
!
8.6
75
!
Publicité
Table des Matières
