Table des Matières
Publicité
EN
G
•
Also make sure that the new fitting situation complies with
the compulsory bumper bar regulations. See Fig. 3.6 for
an example of the important fitting dimensions.
C
Fitting height = Height of centre lift arm to the top
of the loading floor of the vehicle
CO
Height of centre lift arm to the ground
J Max. Max. chassis height
K
Floor height of the vehicle
M
Required overhang
MR
Overhang required to the end of the sliding tubes
•
For SIDE-MOUNTING on truck chassis: when changing
the fitting height C, ensure that the drill holes in the
mounting brackets for the aluminium sliding tubes still fall
within the chassis [See Fig. 3.7].
•
Refer to the TECHNICAL SUMMARY of the
HTL for detail on the correlation between the
arm length, the fitting height and the required
overhang [See Fig. 3.8].
•
For any given platform depth V, the required overhang M
can be reduced by 100 mm with the option S245.S on the
platform [See Fig. 3.9].
DHOLLANDIA
3.6
EX.
3.7
3.8
EX.
[DH-SMR80]
21
3.9
STANDARD
S245.S
!
Publicité
Table des Matières
