Abicor Binzel iCAT Mode D'emploi page 52

6 Putting into operation
®
6.3.2 ABB , Reis
The following figure refers to ABB
1 Robot
Fig. 7 Mounting the corrugated hose clamp
1 Fasten corrugated hose clamp (3) loosely to the robot (1) with cylinder screws (2) such that
a gap of approx. 5 mm between the clamp halves is formed.
6.4 Mounting the hose assembly on the robot
NOTICE
• When mounting liquid-cooled ABIROB
that the mounting bores for the water nipples and the O-rings are lubricated.
• When mounting liquid-cooled ABIROB
that the water nipples in the welding torch coupling ABIROB
inserted correctly into the cable assembly adapter. Observe the forced positioning.
• After mounting is complete, check for any leaks.
• When mounting liquid- and air-cooled cable assemblies, make sure that all lines (control
cable, water hoses, gas/compressed air lines) are installed without torsion and with
sufficient clearance.
EN - 16
® ®
, OTC
®
1
3
2 2 cylinder screws M6x25
.
3
®
W and ROBO WH cable assemblies, make sure
®
W and ROBO WH cable assemblies, make sure
2
Corrugated hose clamp
®
W and ROBO WH are
BAL.0139 • 2018-06-21
iCAT