EBARA 1GP Manuel D'utilisation Et D'entretien page 33

VERSION WITH ON-BOARD PUMP INVERTER (E-SPD)
QP = Protection panel
P = Electric pump 1(2,3,4)
1(2,3,4)
TR = Transducer 1(2,3,4)
1(2,3,4)
INV = Inverter 1(2,3,4)
1(2,3,4)
*Lm = Ferrite, only for MV models
1(2.3)
*Lt = Ferrite, only for TT models
1(2.3)
Notes:
- for connecting the protection panel to the power supply line, see the attached panel manual
- The connections with dash lines are the responsibility of the installer
Note: "Lm" ferrite application (E-SPD MV models)
For single-phase models (E-SPD MV), the ferrite is positioned close to the inverter, encasing the power cable, as shown in the
inverter's specific instruction manual.
Note: "Lt" ferrite application (E-SPD TT models)
For three-phase models (E-SPD TT), the ferrite is positioned encasing the 4 motor power connecting cables, therefore close
to the "MOTOR OUTPUT" terminal block of the inverter internal board.
FERRITE APPLICATION TT
ENGLISH 14