Cleaning - ELMECO BIG BIZ Manuel D'utilisation Et De Maintenance

The machine comes with an new kit "Adapter for cold drink." The use of this particular, it's recommended in the case in
which it dispenses cold drink or when washing the tank with water or similar detergents (sanitizer). In the pictures below
you can see the sequence of assembly and disassembly of the adapter from the transparent tank. It's better not to use
the adapter with products like creams or slush..
Before switching the machine on, it should be cleaned properly
Always comply with the provisions of the local authorities in charge regarding the
cleaning of the machine.
Daily clean and sanitize the machine.
Before carrying out whatever operation, switch off the machine (page 18 pos. F) and
unplug it (pic.3 pag.19).
Use a solution of warm water and sodium hypochlorite (bleach) with the following
proportion: 10 grams (1/2 tea spoon) for each liter of water. Rinse with warm water.
A greater quantity of bleach could damage the augers.
If the plastic parts are dishwashed, ensure the temperature is not higher than 60°C or
140°F, because they could be damaged.
Do not use abrasive powder.
It is recommended to clean the filter at least once a week.
Cleaning is very important if you want the machine to last longer; it is therefore useful to periodically wash all parts in
contact with the product, using the following procedure:
Please see the pictures at the end of this instruction manual, pages 58 and 59:
- During the cleaning procedure, the machine must have the refrigerator system turned off. Select or the "MOTOR ON"
mode, see page 22 or switch off the machine from the button
- Use disposable gloves;
- Empty the tanks by opening the outlets and blocking them (pic.8), moving the little letter from the left to the right.
Leftovers can be kept in the refrigerator in special tanks if allowed by the local authorities in charge;
- Remove the cover, (pic.9), using the key supplied to open them, pour water in the tanks and then empty them;
- In the event the cover has a key lock, use the key provided and remove the;
- Switch the machine OFF from the main power switch and unplug the power plug
- Remove the outlet (pic.20, 21, 22 and 23):
o Remove the lever cover (pic.20) by pushing on both sides and downward and remove the lever (pic.21);
o Rotate the ring nut counter clockwise (pic.22 and 23) and pull the outlet.
- Remove the auger ring nut (pic.10 and 11);
- Remove the tank unscrewing the hooks grips (pic.12), if present, and opening the hooks (pic.13); lift the tank as shown
in pic.14 and 15 Remove the tank gasket (exp.13 pag.56);
- Unscrew the ring nut (pic.16) in order to remove the vertical auger (pic.17);
Adapter for cold drink

Cleaning

Cleaning the tank
- 20 -