Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
When you switch on the machine, the electronic board will have all the LEDs off and the auger will remain stationary. This
mode is called StandBy mode. Auger and the refrigerator system are stopped.
The electronic board will keep the settings it had when the machine was switched off.
• Press the
key to start the augers rotation.
•
Pressing at any time the
•
If you press the
condition in which the augers rotate. According to the setting you can see:
SLUSH 1
The symbol
may be on or off depending on the management of the cold.
•
The SLUSH function allows to have a slush in the tank. The value can vary from 1 to 3 using the
indicates a less or more slush viscosity product respectively.
After each restart of the machine, if the product temperature is higher than 10°C and SLUSH mode is selected,
the led 3 starts to flash for about 2 minutes.
This indicates that the calibration process is taking place. The calibration process will take two minutes to complete.The
machine operates regularly during this period of time.
•
The COLD function, cold drink, it allows to have a liquid and cold product in the tank. During the non-operating time
it is necessary to select this function
•
The MOTOR ON function allow the rotation of the auger keeping the refrigeration system off.
If the LED blinks on the electronic board (1, 2, slush or cold drink), see the table "Trouble Shooting" at the page 25, the
Website "Problem Solving" of www.elmeco.com, or call the service centre.
button the augers stop to rotate and the refrigerator system switchs off.
button, you can select "SLUSH MODE",
SLUSH 2
"COLD MODE"
SLUSH 3
COLD MODE
Self diagnostics
- 22 -
, or return to "MOTOR ON"
MOTOR ON
button and
Publicité
Table des Matières
