Reely Redskin Notice D'emploi page 43

Names of micro switches for the reverse functions (ill. 1c):
1. Nick servo reverse switch
2. Reverse switch for left roll servo
3. Reverse switch for speed controller
4. Reverse switch for the drive motor and the main rotor
5. Not assigned
6. Reverse switch for right roll servo
7. Nick function reverse
8. Not assigned
9. Surface/heli mode switch
10. Activation of the speed controller (6)
to calibrate the roll function
11. Activation switch for the pitch controllers 5+6 (ill. 1a, pos. 5, 6)
12. Not assigned
Caution!
The toggle switch for upside-down flight (ill. 1a, pos. 4) must always be in the lower position (flight mode
"N") and must never be used when the model is operated while on the ground with the rotors not
moving. The rotors would start abruptly, the model could tip over and thus be damaged. Damage
caused by this kind of improper operation is not covered by the warranty/guarantee!
Illustration 1c
43