Evaluating Results - Beurer BC 21 Mode D'emploi

Measuring blood pressure
As described above, attach the cuff and adopt the
posture in which you want to perform the measure-
ment.
• Press the START/STOP button
to start the blood pressure
monitor. All displays will illumi-
nate briefly.
• The last measured value is dis-
played and the blood pressure
monitor automatically begins the
measurement after 3 seconds.
You can cancel the measurement at any time by
pressing the START/STOP button
As soon as a pulse is found, the pulse symbol
be displayed.
• Systolic pressure, diastolic pres-
sure and pulse readings are dis-
played.
• _ appears if the measurement has not been
performed properly. Observe the chapter on error
messages/troubleshooting in these instructions for
use and repeat the measurement.
• Now select the desired user memory by pressing
the memory button M. If you do not select a user
memory, the measurement is stored in the most
recently used user memory. The relevant
symbol appears on the display.
• Press the START/STOP button to switch
blood pressure monitor. The measurement is then
stored in the selected user memory.
If you forget to turn off the device, it will switch off
automatically after approx. 1 minute.
In this case too, the value is stored in the
selected or most recently used user
.
memory.
will
Wait at least 5 minutes before taking
another measurement!

6. Evaluating results

cardiac arrhythmia:
This device can identify potential disruptions of the
heart rhythm when measuring and, if necessary,
indicates this after the measurement with the sym-
bol
This can be an indicator for arrhythmia. Arrhyth-
mia is an illness in which the heart rhythm is abnor-
29
.
or
off the