Evaluating Results - Beurer BC 44 Mode D'emploi

If the values between the two wrists are significantly differ-
ent, please consult your doctor to determine which wrist
should be used for the measurement.
Correct posture
• Rest for approx. 5 minutes before each
measurement. Otherwise there may be
divergences.
• You can perform the measurement either sitting or lying
down. To carry out a blood pressure measurement, make
sure you are sitting comfortably with your arms and back
leaning on something. Do not cross your legs. Place your
feet flat on the ground. It is essential to support your arm
and have it at an angle. Always make sure that the cuff is
level with your heart. Otherwise there may be serious di-
vergences. Relax your arm and the palms of your hands.
• In order not to distort the result, it is important to keep still
during the measurement and not talk.
Measuring blood pressure
• Start the blood pressure monitor with the start/stop but-
ton . A beep and a brief display of all the symbols con-
firm that the device is switched on.
• Before the measurement, the last saved test result is
briefly displayed. If there is no measurement in the memo-
ry, the instrument always displays the value .
• The cuff automatically inflates. Cuff air pressure is re-
leased slowly.
All manuals and user guides at all-guides.com
• If a tendency towards high blood pressure is already de-
• After the pressure has been completely reduced, the sys-
• Measuring can be cancelled at any time by pressing the
•
• The test result is saved automatically.

7. Evaluating results

Cardiac arrhythmia:
This instrument can identify possible cardiac arrhythmia dis-
orders during measurement and if necessary indicates the
measurement with the flashing icon
This may be an indicator for arrhythmia. Arrhythmia is a
condition where the heart rhythm is abnormal as a result of
defects in the bioelectrical system con-
trolling the heart beat. The symptoms
(omitted or premature heart beats, slow
or excessively fast heart rate) may be
caused, among other things, by heart
21
tectable, the cuff is pumped up again and cuff pressure
increased further. The pulse symbol flashes
as a pulse is found.
tolic pressure, diastolic pressure and pulse readings are
displayed.
start/stop button .
_ appears if it has not been possible to perform the
measurement properly. Observe the section in these in-
structions on error messages/troubleshooting and repeat
the measurement.
as soon
.
• • • • • • • • • • • • •