Maintenance; Tips And Tricks; Pin Assignment Of The 13-Pin Connector; Changing The Bulbs - EUFAB AMBER 3 Manuel De L'opérateur

Load the bike carrier so that the maximum payload is not exceeded. See
section 3. Specifi cations.
If you transport an e-bike on rails 1 or 2, the other bikes
must be correspondingly lighter so that the bike carrier is not
overloaded. Before loading, determine the weight of each
bicycle (e.g. using a personal scale).

8. MAINTENANCE

• After use, store the bicycle rack in a clean and dry place. Wash any mud or
other dirt off using water.
• Keep the trailer coupling clean and free of grease
• Keep the rack tow bar clean and free of grease.
• Check the bicycle rack regularly for damages. Damaged or worn parts must
be replaced immediately. Only original replacement parts may be used.
• Check the bolts and nuts of the bicycle rack regularly and tighten when
necessary.
• Immediately treat any damage to paintwork with paint.
• Regularly lubricate rotating and moving parts.

9. TIPS AND TRICKS

9.1 PIN ASSIGNMENT OF THE 13-PIN CONNECTOR

Left indicator
Rear fog light
Ground for contact 1 - 8
Right indicator
Right-hand tail light
(incl. marker light)
Brake light
Left-hand tail light
(incl. marker light)
Reversing light
Steady current (steady plus)
Charging cable
Charging cable -/ ground
(for battery in trailer)
Control cable for trailer identifi cation
(connection)
against ground pin 3 in trailer
Ground for contact (power supply)
Plug
58L
L
54
54G
R
58R
31
31
12
Pin 1, L yellow
Pin 2, 54G blue
Pin 3, 31 white
Pin 4, R green
Pin 5, 58R brown
Pin 6, 54 red
Pin 7, 58L black
Pin 8 grey
Pin 9 not used brown/blue
Pin 10 not used brown/red
Pin 11 not used
Pin 12
Pin 13 not used white/black
Socket
58L
L
54
54G
R
58R
31
31

10. CHANGING THE BULBS

Required tools: Screwdriver of PH1 size. Unscrew the cross-head screws of the
lens and remove the lens. Press the bulb to be replaced lightly into the socket
and then turn it a quarter of a turn. Now remove the bulb from the socket.
Insert the new bulb in the appropriate position.
List of bulbs:
Brake light/ Rear light: 12 V 21/5 W BAY15d
Indicator: 12 V 21W
Rear fog light: 12 V 21W
Reverse light: 12 V 21W
Licence plate illumination: 12 V 5W

11. NOTES FOR ENVIRONMENTAL PROTECTION

As the bicycle rack has a lighting system, it is subject to the
Ordinance on Waste Electrical and Electronic Equipment and
must be disposed of as waste electrical and electronic equipment
once its service life has expired.
The materials are recyclable. You make an important contribution
to protecting our environment by recycling, material utilisation
or other forms of reusing waste equipment.

12. CONTACT INFORMATION

EAL GmbH
Otto-Hausmann-Ring 107
42115 Wuppertal, Germany
+49 (0)202 42 92 83 0
+49 (0) 202 42 92 83 – 160
BAU15S orange
BA15S
BA15S
SV8,5 11 x 38 (Soffi t)
info@eal-vertrieb.com
www.eal-vertrieb.com