Transport Of E-Bikes - EUFAB AMBER 3 Manuel De L'opérateur

the trailer tow bar. Undo the lock nut of the adjusting screw and rotate the
adjusting screw on the quick locking mechanism tighter by a quarter turn.
Then tighten the lock nut again.
Replace the rack back on the trailer tow bar and check whether the rack is
securely and fi rmly positioned on the tow bar. Repeat the adjustment process
until the rack is secure and fi rm.
CAUTION
Always make sure that the lock nut of the adjusting
screw is correctly tightened!
Slight signs of pressure on the two bar ball are normal
and do not infl uence the functionality.
When the rack is fi rmly seated on the trailer tow bar, rotate the securing bolt
of the quick locking mechanism until it engages. Now close the quick locking
mechanism with the supplied padlock and remove the key from the lock.
Store the key carefully and in a safe place. The bicycle rack is now secured to
prevent theft.
Regularly check the fi rm seating of the rack on the trailer tow bar as well as
the attachment of the bicycles to the rack. Also regularly check the functions
of the lighting system of your bicycle rack.
Folding mechanism
If you wish to operate the folding mechanism, always hold the
U-bracket with one hand to ensure that the rack is not able to
fold out suddenly. (Risk of injury)
To open the car boot, you may fold the rack down, even if bicycles are mounted.
To do this, fi rst loosen the block of the folding mechanism by pushing the
locking bolt down (1)and pushing the handle away from you (2). Hold the
U-bracket or bicycles with one hand, with the other hand pull the lever of the
folding mechanism upwards(). Now you can fold the rack down.
Folding the bicycle rack up
Raising the rack platform engages it back into the transport position (you will
hear a click). Secure the folding mechanism again by pushing the locking bolt
down and pulling the handle towards you.
1
2
3
The rack may not be used without the additional lock
securing mechanism.
Mounting the bicycles to the rack
Since the frame holders are not tied to any specifi c position, you may try out
a number of positions. It is important to ensure that the frame holder is fi tted
as high as possible.
Position the fi rst bicycle in the fi rst wheel rail (the wheel rail closest to the
vehicle). Connect the frame of the bicycle to the U-bracket using the short
frame holder.
Place the second bicycle in the middle wheel rail, facing the opposite direction
to the fi rst. Connect the frame of the second bicycle to the U-bracket using the
long frame holder.
Place the third bicycle in the third wheel rail, facing the opposite direction
to the second. Connect the frame of the third bicycle using the loose frame
holder (the one with two tensioning straps) to the frame of the second bicycle
Secure the wheels with the supplied short tensioning straps. Use one
tensioning strap to secure the rear wheel and two for the front wheel (see
picture) to prevent them from turning.
Now secure the bicycles with the long safety strap. Wrap the safety strap
through the bicycle frames and the U-shaped bar and tighten.
The bicycle rack may not be used without this safety
strap.
Safety strap
The bicycles are removed in reverse order.

7. TRANSPORT OF E-BIKES

When transporting e-bikes, the payload of the bicycle
carrier and the maximum load capacity of each individual
bicycle rail must not be exceeded.
Mount e-bikes only on the bicycle rails 1 and 2, see picture. Mount e-bikes only on the bicycle rails 1 and 2, see picture.
Maximum load capacity of the Maximum load capacity of the
bicycle rails:
rail 1: 27.5 kg
rail 2: 27.5 kg
rail 3: 20.0 kg
11 11