Connecting; Checking The Machine; Operating; Prior To Commissioning - Graef Concept Line Série Mode D'emploi

The support must comply with the following requirements:
- Sufficiently robust, stable, level and horizontal.
- Sufficiently high for upright body posture during cutting.
- Space requirement according to the following list (see Table under point 2.4)
- Install the machine away from in-house traffic routes.
- Install the machine away from doors. Not in the pivoting range of an opening door,
not in the access area of a door.
- With stainless tables, Resopal supports or similar materials, ensure that no
grease residues are on the surface area.

4.3 Connecting

- Check that the local operating voltage corresponds to the specifications on the type plate.
In case of deviations, you must not connect the machine.
- Electrical socket must comply with the national safety regulations (in Germany: VDE).
Technical data for power supply
– Power connection Single-phase alternating current, refer to rating plate
- The machine is designed according to protection class I and must be connected to a grounding conductor
– Permissible tolerance for voltage (static) normal
For 100 to 230V: +6% to -10% of nominal value
– Power frequency: 50 (60) Hz
Permissible tolerance for power frequency: +2% to -2% of nominal value
– Max. discharge current protective conductor: 3.5 mA
- Take measures on site if the grid is "unclean", that means
if thyristor controlled devices are used in the grid or grid asymmetries prevail
that lead to voltage peaks.
- Lead the power cable away backwards in order to exclude stumbling over the cable.

4.4 Checking the machine

- Check the protective devices according to point 3.7.
- Check if the machine moves when it is switched on. Does it, or the
support on which it stands, start moving away? If yes, provide a firmer support.

5 Operating

5.1 Prior to commissioning

Check the protective devices according to point 3.7.
DANGER
Rotating blade! Can cut off finger. Turn the adjusting knob for cut thickness setting
clockwise to the end stop. Do not reach into the running blade.
42