Programming The Speed Controller; Adjusting The Neutral And Full Throttle Setting - Reely 1:10 Monster Truck électrique «Bad 1» 4WD RtR Notice D'emploi

10. Programming the speed controller

a) Adjusting the neutral and full throttle setting
If the vehicle does not stay stationary when the throttle/brake lever is in the neutral position, you can adjust the throttle
trim on the remote control.
If the trim is insufficient (or if the trim is almost in the end position), you can reset the trim accordingly.
Proceed as follows:
• Switch on the remote control and leave the throttle/
brake lever in the neutral position. Set the trim for the
drive function to the neutral position.
• Switch on the speed controller using the on/off switch
(A). Hold down the setup button (B) and turn on the
speed controller (move the switch to the "ON" position).
• The LED on the speed controller will flash red and the
motor will start to beep. Release the setup button.
If you do not release the setup button, programming
mode will be enabled after a few seconds (see section
10. b). If this occurs, switch off the speed controller and
repeat the above steps.
The beeps are produced by the brushless motor. Depending on the motor, the beeps may be very quiet. If
so, pay attention to the status of the LED on the speed controller.
• Release the throttle/brake lever on the remote control so that it is in the neutral position.
• Press the setup button (B). The LED on the speed controller will flash once in green and the vehicle will beep. This
indicates that the neutral setting has been saved.
• Move the throttle/brake lever to the full forwards throttle position (move it towards the handle and hold it in place).
Warning!
If you do not move the transmitter throttle/brake lever during the settings process, or you do not move it far
enough, the vehicle may respond to even slight movements of the throttle lever or become uncontrollable.
If this occurs, reprogram the throttle settings.
• Press the setup button (B). The LED on the speed controller will flash twice in green and the vehicle will beep twice.
This indicates that the full throttle settings for the forwards throttle have been saved.
• Move the throttle/brake lever to full reverse throttle (push the lever away from the handle as far as it will go).
• Press the setup button (B). The LED on the speed controller will flash three times in green and the vehicle will beep
three times. This indicates that the full throttle settings for the reverse throttle have been saved.
• Release the throttle/brake lever to return it to the neutral position.
• Wait for at least three seconds. The speed controller will automatically exit settings mode and apply the new set-
tings.
54