Requirements For The Place Of Operation; Electrical Connection - Beem Hoberg Samowar Mode D'emploi

Samowar 3L
WARNING
► Never heat any other liquids in the
appliance other than water.
Danger from hot steam and hot water!
► Never fill the appliance above the
maximum mark (3).
► Do not open the lid of the water tank
while water is boiling; spurting hot
water and escaping steam can lead to
scalding.
Danger to health from germs!
► The water tank of the appliance must
be completely emptied, cleaned and
disinfected at regular intervals to
avoid the risk of cultivation of danger-
ous germs.
CAUTION
► Do not use sharp objects or abrasive
cleaning agents to clean the surfaces.
► Never lift or move the appliance with
the mains cable.
► Do not pull the connecting cable to re-
move the plug from the mains socket.
► Never operate the appliance when the
jug is empty.
18
Requirements for the place of
operation
For safe and trouble-free operation of the
appliance, the installation location must sat-
isfy the following requirements:
■ Place the appliance on a firm, dry, flat,
waterproof and heat-resistant surface.
■ Do not install the appliance in a hot, wet
or very humid environment.
■ The mains socket must be easily acces-
sible and allow fast disconnection in the
event of an emergency.
■ The surface finishes on furniture may
contain substances that can be detri-
mental to the feet of the appliance. If
necessary, place a mat under the feet of
the appliance.
■ Make sure that there is a sufficient dis-
tance to heat-sensitive surfaces to walls
and furniture for example.

Electrical connection

For safe and trouble-free operation of the
appliance, the following instructions on the
electrical connection must be be observed:
■ Before connecting the appliance, com-
pare the connection data (voltage and
frequency) on the rating plate with those
of your mains power supply. This data
must correspond in order to avoid dam-
age to the appliance. If in doubt, ask
your electrical appliance retailer.
■ The mains socket must be protected by
at least a 16 A automatic circuit breaker.
■ Make sure that the connecting cable is
undamaged and is not laid over sharp
edges.
EN