Electrical Connections; Electric Heater Insulation Resistance; Elektroanschlüsse; Isolationswiderstand Des Elektrosaunaofens - Sentiotec 360C Instructions D'installation Et Mode D'emploi

Table des Matières

Publicité

EN
Shut-off valve
Absperrventil
Cold water
Kalt Wasser
Max 1 MPa
(10 bar)
Figure 8.
Automatic filling
Abbildung 8. Automatische Wasserbefüllung

3.7. Electrical Connections

The heater may only be connected to the electrical
network in accor dance with the current regulations
by an authorised, professional electrician.
The heater is semi-stationarily connected to the
junction box on the sauna wall. See fig. 7. The con-
nection cable must be of rubber cable type H07RN-F
or its equivalent.
NOTE! Due to thermal embrit tlement, the use
of PVC-insulated wire as the connection cable of
the heater is forbidden. The junction box must be
splash-proof, and its maximum height from the floor
must not exceed 50 cm.
If the connection and installation cables are higher
than 100 cm from the floor in the sauna or inside
the sauna room walls, they must be able to endure
a minimum temperature of 170 °C when loaded (for
example, SSJ). Electrical equipment installed higher
than 100 cm from the sauna floor must be approved
for use in a temperature of 125 °C (marking T125).

3.8. Electric Heater Insulation Resistance

When performing the final inspection of the electri-
cal installations, a "leakage" may be detected when
measuring the heater's insulation resistance. The
reason for this is that the insulating material of the
heating resistors has absorbed moisture from the
air (storage transport). After operating the heater
for a few times, the moisture will be removed from
the resistors.
Do not connect the power feed for the heater
through the RCD (residual current device)!
18
DE
400 V
N
N
N
U V
3N~
Figure 9.
Electrical connections of the heater
Abbildung 9. Elektroanschlüsse des Saunaofens
3.7. Elektroanschlüsse
Der Anschluß des Saunaofens ans Stromnetz darf nur
von einem zugelassenen Elektromonteur unter Beachtung
der gültigen Vorschriften ausgeführt werden.
Der Saunaofen wird halbfest an die Klemmdose
an der Saunawand befestigt. Siehe Abb. 7. Als An-
schlußkabel wird ein Gummikabel vom Typ H07RN-F
oder ein entsprechendes Kabel verwendet.
ACHTUNG! PVC-isolierte Kabel dürfen wegen ihrer
schlechten Hitzebestän digkeit nicht als Anschlußkabel
des Saunaofens verwendet werden. Die Klemmdose
muß spritzwasserfest sein und darf höchstens 50 cm
über dem Fußboden angebracht werden.
Falls der Anschluß oder die Montagekabel in die
Sauna oder die Saunawände in einer Höhe über
100 cm über dem Boden münden, müssen sie belastet
mindestens eine Temperatur von 170 °C aushalten
(z.B. SSJ). Elektrogeräte, die höher als 100 cm
vom Saunaboden angebracht werden, müssen für
den Gebrauch bei 125 °C Umgebung stemperatur
zugelassen sein (Vermerk T125).
3.8. Isolationswiderstand des
Elektrosaunaofens
Bei der Endkontrolle der Elektroinstallationen kann
bei der Messung des Isolationswiderstandes ein
"Leck" auftreten, was darauf zurückzuführen ist, daß
Feuchtigkeit aus der Luft in das Isolationsmaterial
der Heizwiderstände eingetreten ist (bei Lagerung
und Transport). Die Feuchtigkeit entweicht aus den
Widerständen nach zwei Erwärmungen.
Schalten Sie den Netzstrom des Elektrosaunaofens
nicht über den Fehlerstromschalter ein!
2
1
400 V
W
W1
P
N
N
3N~
2
1
N
U
V W
W1 P

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

390c360ca390caViking combi

Table des Matières