Flue Pipe Connection; Butterfl Y Valve; Fuel Load Sizes And Thermal Output; Regulating The Combustion Air - HASE Granada Mode D'emploi

5.

Flue Pipe Connection

The Granada / Kyoto has to be connected to the chimney with a fl ue pipe having an inside
diameter of 15 cm. Please ensure a tight fi t of all pipe pieces at the connection junctions. The
pipe must be well sealed in the chimney entrance and cannot project into the inner cavity
of the chimney; otherwise the fl ue venting will be impaired.
6. Butterfl y Valve
The butterfl y valve is an optional control element. It is fi tted in the fl ue pipe and used to
regulate the fl ue gas fl ow, and can thus slow down the burning-off process. When the
handle's position is diagonal to the fl ue pipe, the fl ue gas fl ow rate is turned to minimum.
We strongly recommend the installation of a butterfl y valve to reduce the output pressure.
Please consider the country-specifi c statutory regulations.
7.

Fuel Load Sizes and Thermal Output

The thermal output depends on the amount of fuel you burn in the stove (fuel load size).
When adding more fuel (e.g. wood), the maximum fuel load size is 3 kg. Exceeding the
maximum fuel load size leads to a danger of overheating, possibly resulting in damage to
the stove and risk of a stove fi re.
A thermal output of 9 kW can be attained by burning wood logs weighing ap-
prox. 2,5 kg and approx. 25 cm in length for approx. 45 min.
To attain thermal output of 4,5 kW, burn wood logs weighing approx. 0,5 kg and
approx. 25 cm in length for approx. 20 min.
The Granada / Kyoto is intended for intermittent operation, please only apply one fuel
layer at a time.
8.

Regulating the Combustion Air

When lighting the fi re and adding fuel, the combustion air is regulated with the primary air
and secondary slider.

8.1 Primary Air

The primary air is guided through the grate and into the fi re box from below, thus more
quickly achieving the required fi re box temperature during the warming up phase.
57