Lifting The Vehicle; Lowering The Vehicle - ATT NUSSBAUM SPRINTER MOBIL 2500 Manuel D'exploitation

5.1

Lifting the vehicle

Warning! The hydraulic lines may not be driven
!
over. This can lead to damage and, if leaks re-
sult, even to the lift sinking.
The total centre of mass must be considered.
!
If required, use the ramps for safe acceptance
i
of the vehicle.
• Secure the vehicle against rolling; pull the hand
brake, engage the gears.
• Inspect the hazardous area.
No person or object may stand in the working
area of the lift, or on the lift.
• Switch on controls. Turn the main switch (2) to po-
sition "1" (see fi gure 007).
• Position polymer overlays below the points speci-
fi ed by the vehicle manufacturer. The polymer
overlays may not be placed on edge, otherwise
the vehicle could fall.
• Lift the vehicle. Push the "LIFT" (3) button.
• If the wheels are not blocked, interrupt the lifting
process and check for proper seating of the poly-
mer overlays.
• Raise the vehicle to the desired working height.
AD H9451 12.06.2015
010
SPRINTER MOBIL - HYMAX PRO
• Then position the operating unit in such a way
that the fl exible hose package (protective and
hydraulic hose) cannot be damaged by external
infl uences (such as being driven over by the load).
5.2

Lowering the vehicle

Warning! The hydraulic lines may not be driven
!
over. This can lead to damage and, if leaks re-
sult, even to the lift sinking.
• Inspect the hazardous area. No person or object may
stand in the working area of the lift, or on the lift.
The vehicles cannot be lowered into the lowest
!
position without wheels. Otherwise the lift can-
not raise the load using its own force. The vehi-
cle could be damaged.
• Lower the vehicle to the desired working height. Push
the "LOWER" button (4) (see fi gure 007).
• The system is equipped with an optional CE-STOP
During "LOWER" (4) to the lowest position, the sys-
tem stops at a height of 300 mm.
To allow the system to lower further, it is neces-
sary to release the "LOWER" button (4) and press it
again.
A signal tone sounds until the system has reached
the lowest position.
• The entire lowering process must be observed.
• If the lift is in the detectable lowest position, re-
move the polymer overlays and drive the vehicle
from the lift.
015
59