Safety Regulations; Safety Inspection - ATT NUSSBAUM SPRINTER MOBIL 2500 Manuel D'exploitation

3

Safety regulations

When working with systems comply with legal
accident prevention regulations according to
BGG 945, inspection of lifts; BGR 500 and operation
of systems; VBG 14.
Particular attention is drawn to compliance with the
following regulations:
• When operating the system, follow safety regula-
tions and operating instructions in the operating
manual.
• The total weight of the accepted load may not
exceed
- 2,500 kg for SPRINTER MOBIL 2500 - HYMAX PRO
2500 and
- 3,000 kg for SPRINTER MOBIL 3000 - HYMAX PRO
3000,
where a maximum load distribution of 3:2 or 2:3
in or against the drive-in direction is permitted.
• Only personnel aged 18 or over may operate
systems independently, they must be trained in
system operation and have their work verifi ed by
the company. They must be explicitly tasked with
operating the system (excerpt from BGR 500),
see transfer protocol.
• Operation of the system is only permitted on a
smooth, solid surface.
• During lifting or lowering, the work area of the sys-
tem should be clear or people.
• It is prohibited from moving people with the lift.
• It is prohibited to climb onto the system.
• After design and maintenance on load bearing
parts the system must be inspected by a techni-
cal expert.
• Initial access into the system may only be done
after the main switch (2) is off and locked.
• For vehicles with low fl oor clearance or custom
equipment, check in advance whether it could
be damaged.
• Consider any possible centre of mass shifts when
disassembling heavy vehicle components.
54
3.1

Safety inspection

The safety inspection is required to guarantee
operational safety of the lift system. It is to be done:
1. Before fi rst commissioning after setting up the lift
system use the "single safety inspection" form
2. After fi rst commissioning, check regularly at
least once per year.
Use the "regular safety inspection" form
3. After changes to the lift system construction
Use the "extraordinary safety inspection" form
Single and regular safety inspections must be
!
done by a specialist. It is recommended to do
maintenance at the same time.
After a change in construction (for exam-
i
ple changing the load carrying capacity or
changing the lifting height) and after sig-
nifi cant maintenance on load carrying parts
(e.g. welding work), inspection by a technical
expert is required (extraordinary safety inspec-
tion)
This inspection book contains forms with a detailed
inspection plan for safety inspections. Please use
the appropriate form, record the condition of the
inspected system and leave the completed form in
this inspection book.
SPRINTER MOBIL - HYMAX PRO 12.06.2015 AD H9451