Maintenance And Care Of The System; System Maintenance Plan; As Required Or Visible Damage; Maintenance 1 X Per Year - ATT NUSSBAUM SPRINTER MOBIL 2500 Manuel D'exploitation

6 Maintenance and care of the
system
Before maintenance, do all prepara-
tion work so there is no danger to life or
limb or object damage during mainte-
nance and repair work.
Value is placed on long lifetimes and safety in
the development and production of Nußbaum
products. To guarantee the safety of the opera-
tor, product reliability, low running costs, keep the
warranty and also the long-lifetime of the product,
proper set up and operation is just as important as
regular maintenance and suffi cient care.
Our platforms fulfi l or exceed all safety standards of
the countries we supply to. For example, European
regulations require a service by qualifi ed experts
every 12 months of work of the platform. To guaran-
tee the largest possible availability and functional
capacity of the lift system, ensure the list of any
cleaning, care and maintenance work is done.
The lift system is to be serviced at regular inter-
vals according to the following plan. For intensive
operation and higher degree of contamination
shorten the service interval.
The complete function of the lift system is to be
observed during daily use. Customer service must
be informed of any malfunctions or leaks.
To simplify maintenance work, follow instructions on
the maintenance sticker that is found somewhere
on the unit, depending on the lift design.
60
6.1

System maintenance plan

Before beginning service, disconnect
from power. The system is to be se-
cured against unintentional lowering
and unauthorized access.

6.1.1 As required or visible damage

6.1.2 Maintenance 1 x per year

• Check condition of the model plate, load
capacity and sticker.
damaged or illegible.
• Check condition of the model plate, load
capacity and sticker. Exchange them if damaged or
illegible.
• Free the piston rod of the lifting cylinder of sand
and dirt.
• Check the wiper for damage.
• Moving parts such as joint bolts and DU bearings,
sliding pieces, sliding surfaces and rollers are to
be cleaned and checked for wear, exchange if
required.
• Moving parts such as joint bolts, sliding pieces and
sliding surfaces are to be cleaned and checked
for wear and lightly greased. Do not over-lubri-
cate.
• Check the polymer overlays and replace if re-
quired.
• Check all available safety devices for function.
• Check the state and function of the mobile set.
• Check ease of motion of the tow bar (8), guide
roller (6) and wheel axles (9).
SPRINTER MOBIL - HYMAX PRO
Exchange them if
12.06.2015 AD H9451