Assembly And Commissioning; Set Up Guidelines; Commissioning - ATT NUSSBAUM SPRINTER MOBIL 2500 Manuel D'exploitation

4

Assembly and commissioning

4.1

Set up guidelines

• There is the option to anchor the lift on an existing
concrete fl oor with a quality of min. C20/25, con-
crete thickness min. 160 mm (normal reinforce-
ment).
• To protect the electrical cable all cable con-
duits are to be fi tted with cable sleeves or fl exible
plastic pipes.
• After successful lift installation and before fi rst
commissioning, the operating company must
have the lift grounding conductors inspected on-
site according to IEC regulation (60364-6-61). An
insulation resistance test is also recommended.
• The anchoring of the lift must be carried out
by trained manufacturer personnel or a contract
partner. If the operating company has appropri-
ately trained assemblers, the system can also be
set up by them. Set up is to be done according to
the assembly instructions.
• A standard system may not be set up in explosion
endangered spaces or wash halls.
• Provide an on-site electrical connection of 3 ~/N
+ PE, 400 V, 50 Hz, fuses with 16 A, slow.
The foot bumper (15) must always be mounted
i
with the orange sticker (16) on the side where
the cylinder (17) is located.
18
15
15 Foot bumper
16 Orange sticker
17 Cylinder
18 Load capacity sticker
AD H9451 12.06.2015
16
17
022
SPRINTER MOBIL - HYMAX PRO
4.2

Commissioning

3
4
The SPRINTER MOBIL - HYMAX PRO has been
i
inspected and accepted by Nußbaum. The test
need no longer be carried out by a specialist
before initial commissioning.
- Remove the front cover hood (1)
- Loosen and remove the sealing screw (5) of the
oil tank
5 Oil fi lling opening
- Fill new hydraulic oil (e.g. HLP 32). About 8 litres
are needed.
2
1
1 Cover hood
2 Main switch
3 "LIFT" button
4 "LOWER" button
5
026
55