Changing The Assembly Location - ATT NUSSBAUM SPRINTER MOBIL 2500 Manuel D'exploitation

- Provide an on-site electrical connection of 3 ~/N
+ PE, 400 V, 50 Hz, fuses with 16 A, slow.
- Connect the electric cable to the customer-pro-
vided mains breaker (e.g. a Cekon plug).
- Turn on main switch (2) and press the "LIFT"
button (3).
If the lift does not move upwards after a few
!
seconds, the direction of rotation of the motor is
incorrect. Swap 2 phases on the plug.
- Then press the "LIFT" button (3) again and raise
and lower the lift to its limit positions several times
without load. This will largely ventilate the hydrau-
lic system.
4.3

Changing the assembly location

- To operate the lift, it must be raised about
500 mm so that the back wheel axes (9) and
guide roller (6) can be engaged.
8
7
6 Guide roller
7 Torsion shaft
8 Towing bar
9 Wheel axles
56
9
6
- Place the guide rollers (6) over the torsion shafts
(7). Then push them until the tappet (10) is
located in the notch (11) of the guide
roller.
003
6 Guide roller
10 Tappet
19 Guide roller holder
- The wheel axles (9) are in the lower plate of the
lift (12).
9
9 Wheel axle
12 Wheel axle storage
To simplify mounting, it may be necessary to
i
raise or lower the lift a little.
Then lower the lift completely. Hang the tow
004
bar (8) into the guide roller (6) and the lift can then
be moved.
To remove the roller, follow the instructions in the
reverse order.
The mobile hand unit quickly makes the SPRINTER
MOBIL - HYMAX PRO ready to use again.
SPRINTER MOBIL - HYMAX PRO
6
11
10
11 Notch
12
12.06.2015 AD H9451
19
005
019