System Master Sheet; Manufacturer; Purpose; Changes To The Design / Construction - ATT NUSSBAUM POWER LIFT HDL 6500 SST DG Manuel D'exploitation

2

System master sheet

2.1

Manufacturer

Otto Nußbaum GmbH & Co.KG
Korker Straße 24
D-77694 Kehl-Bodersweier
2.2

Purpose

The lift is a lifting tool for raising vehicles up to a total weight of 6,500 kg or 7,000 kg or 8,000 kg for normal
workshop operation, for a maximum lift distribution of 3:1 in the drive-in or against the drive-in direction.
The set up of the standard lift is not permitted in explosion endangered work shops and washing halls.
The lift is not set up for moving people.
After construction and significant maintenance changes on load carrying parts the lift must be inspected
afterwards by a specialist who approves the changes.
2.3 Changes to the design / construction
Inspections by a technical expert are required before recommissioning (date, type of change, technical
expert signature).
______________________________________________________________________________________________________
______________________________________________________________________________________________________
Name, address of technical expert
_________________________________________________
Location, date
2.4

Changing the assembly location

Inspections by a technical expert are required before recommissioning (date, type of change, specialist
signature).
______________________________________________________________________________________________________
______________________________________________________________________________________________________
Name, address of technical expert
_________________________________________________
Location, date
OPI-POWER LIFT HDL 6500 SST DG-7000 SST DG-8000 SST DG - HYMAX H 6500 DG-H 7000-V1.0-DE-EN-FR-ES-IT
_________________________________________________
Technical expert signature
_________________________________________________
Signature of Technical Expert of Safety inspections
95