ATT NUSSBAUM POWER LIFT HDL 6500 SST DG Manuel D'exploitation page 111

Do an emergency discharge
• Switch off the main switch and secure against re-
start (shut down).
• Loosen and remove all unit covers.
• For safety reasons, block off the endangered
area and the lift leaving ample room.
• Loosen and remove 2 counter nuts (spanner
width 41) at the upper end of the lift rails in the di-
rection of the arrow. This procedure must be done
on all lift rails.
Figure 6
• The piston rods can jam in the upper bore of the
lift rail when they are limited by any contamina-
tion deposits. To loosen these connections, we
recommend a commercially available solvent
and simultaneous lubricant (e.g. WD40). Spray
this penetrating spray generously between the
thread and bore. The treatment time depends on
the degree of contamination.
Figure 7
• The cover of the mini-measurement connection
and the tank cover must be loosened. Unscrew
the corresponding mini-measurement hydraulic
line approx. 500 mm long (available from your
dealer) and guide into the tank.
OPI-POWER LIFT HDL 6500 SST DG-7000 SST DG-8000 SST DG - HYMAX H 6500 DG-H 7000-V1.0-DE-EN-FR-ES-IT
Figure 8
• Screw on the long threaded sleeve (available
from your dealer) and tighten clockwise using a
suitable tool (spanner width 24) Lower the lift rails
approx. 5-10 cm. Repeat the process on the next
lift rails etc. The lift rails may only be lowered in
steps of 5-10 cm until the entire lift has reached
the lowest position.
Figure 9
Warning!! Only lower each column
alternately by a max. of 5-10 cm oth-
erwise there is a danger of falling.
The entire emergency discharge must always
i
be observed by the operator.
i The lift must be stopped until the defective parts
are exchanged.
The lift may only be operated again
once it has been returned to a seam-
less condition seen from a safety point
of view.
• Afterwards, do a reset as described in the oper-
ating manual.
111