ATT NUSSBAUM POWER LIFT HDL 6500 SST DG Manuel D'exploitation page 108

1 LED OUT 1
2 LED OUT 2
3 LED OUT 3
4 LED OUT 4
5 2 LED RED ENCODER AXIS 1
6 2 LED RED ENCODER AXIS 2
7 2 LED RED ENCODER AXIS 3
8 2 LED RED ENCODER AXIS 4
9 X603 X604 4 JUMPER FOR
INTERFACES SWITCHOVER
10 X601 RS232- CONNECTOR
11 GREEN LED: USB RECEIVING
12 RED LED: USB TRANSMITTING
13 X600 USB TYPE B CONNECTOR
14 X602 2XCAN BUS CONNECTOR
15 JP600 CAN 1 TERMINATION
16 S1100 CPU RESET BUTTON
17 JP601 CAN 2 TERMINATION
18 GREEN LED: CAN STATUS
19 RED LED: CAN STATUS
20 JP1100 JUMPER FOR PROGRAMMING
21 S1101 DIP SWITCHES 1-8
22 X1101 CONNECTOR FOIL KEYBOARD
Designator: JP1100
Purpose
Open
Closed
Standard
Designator: JP600
Purpose
Open
Closed
Standard
OPI-POWER LIFT HDL 6500 SST DG-7000 SST DG-8000 SST DG - HYMAX H 6500 DG-H 7000-V1.0-DE-EN-FR-ES-IT
108
Programming mode See
description Programming
the μControllers
Normal operation
Programming
Open
Can BUS 1
See below under CAN-
Bus
No termination
120 Ω termination
Closed
23 X1100 DISPLAY CONNECTOR
24 GREEN LED: CPU STATUS (FLASHES)
25 P1101 POTENTIOMETER CONTRAST DISPLAY
26 X501 ZERO JUMPER PIC
27 LED GREEN 5 V
28 LED GREEN 3.3 V
29 RED LED: IN 1
30 RED LED: IN 2
31 RED LED: IN 3
32 RED LED: IN 4
33 RED LED: IN 5
34 RED LED: IN 6
35 RED LED: IN 7
36 RED LED: IN 8
37 GREEN LED: RELAY K500
38 GREEN LED: RELAY K700
39 X901 64-PIN CONNECTOR STRIP
40 K700 RELAY CPU MONITORING
41 K500 RELAY PIC MONITORING
42 LED PWM 1
43 LED PWM 2
44 LED PWM 3
45 LED PWM 4
Designator: X501
Purpose
Closed
Standard
Potentiometer P1101 contrast for LCD Display
The contrast for the LCD display can be adjusted
with the P1101 potentiometer.
After changing a display this must be reset under
certain circumstances, especially if the dis-play
does not appear or there are black squares.
Reset S1100 button
After activation of the S1100 button the micropro-
cessor performs a reset, i.e. the program restarts.
This is similar to switching on the 24V supply voltage
again.
DIP switch S1101
The sliding switches 1 to 8 of the S1101 switch block
can be switched off and on. The position on the
side with the designation „ON" means that the
switch is turned on.
Zero PIC
See description PIC
Zeroing after switching
on if opened within 2s
Open