System Master Sheet; Manufacturer; Purpose - ATT NUSSBAUM POWER LIFT HF 3S 3000 Manuel D'exploitation

2

System master sheet

2.1

Manufacturer

Nussbaum Custom Lifts GmbH
Hertz Str. 6
D-77694 Kehl-Sundheim
2.1

Purpose

The lift is a lifting tool for raising vehicles with a total weight of (* see list) in normal workshop operation at a
maximum load distribution of (2:3**) (1:3***) in or against the drive-in direction A single load from only one
or two lifting arms may not happen.
Set up of the standard lift in explosion endangered workshops and humid spaces (e.g. washing halls) is
prohibited.
Lift operation is done directly on the operating column (see Data sheet).
After construction and maintenance changes on load carrying parts the lift must be inspected afterwards
by a specialist who approves the changes. If the set up location is changed, the lift must be checked
again by a specialist and changed approved.
(*)Load carrying capacity of the POWER LIFT HF 3S series:
POWER LIFT HF 3S 3000** = HYMAX HF 3S 3000 = 3,000 kg
POWER LIFT HF 3S 3500** = HYMAX HF 3S 3500 = 3,500kg
POWER LIFT HF 3S 4000 *** = HYMAX HF 3S 4000 = 4,000 kg
Lifting arm variants
Standard arms
MINI-MAX arms (MM)
Universal Lifting arm
DT* Lifting arm
Sport Cars lifting arm
(SC)
Otto lifting arms MM
Otto lifting arms
*DT = Double telescope lifting arms (previously MB arms)
OPI-POWER LIFT HF 3S 3000-4000-V3.2-DE-EN-FR-ES-IT
HF 3S 3000 HF 3S 3500
590 – 900 mm 505 – 823 mm
940 – 1495 mm 940 – 1495 mm
560 – 1030 mm
1000 – 1545 mm
–
480 – 870 mm 570 – 1160 mm
940 – 1495 mm 940 – 1495 mm
– 590 – 865 mm
840 – 1380 mm
–
–
HF 3S 3500 DG
"OTTO ARM"
–
– –
– –
–
–
– 600 – 980 mm
995 – 1823 mm
– 570 – 1160 mm
995 – 1823 mm
HF 3S 4000
600 – 900 mm
1130 – 1840 mm
635 – 1065 mm
1130 – 1840 mm
570 – 1160 mm
1130 – 1840 mm
–
–
–
–
69