Lifting The Vehicle - ATT NUSSBAUM POWER LIFT HF 3S 3000 Manuel D'exploitation

Version with Mini-Max lifting arms
Figure 1: Position carrier plate below the fixture points approved
by the vehicle manufacturer.
Figure 2: If required, place the carrier plate by pushing the lever
at the fixture points.
Ensure that the ratchet is securely locked into
!
the intended position. Otherwise the „Mini-Max"
can sink to its lowest position.
Figure 3: To release the fixture plate, the rear lever must be
pushed.
• The lifting arm block must be ratcheted in after
the fixture point has been reached.
• After each set down of the vehicle, check the lift-
ing arm positions below the fixture points again
and adjust as required.
• Check that there are no people or objects in the
hazardous area of the lift.
86
5.2

Lifting the vehicle

• Lift the vehicle until the wheels are off the ground.
Push the operating lever forwards v "Lift" (see
fi gure 4).
• If the wheels are not blocked, interrupt the lifting
process and check for proper seating of the car-
rier plate. Similarly check whether the lifting arm
blocks are ratcheted in. Otherwise, lower the lift
and reposition the vehicle.
• After each set down of the vehicle, check the lift-
ing arm positions below the fixture points again
and adjust as required.
• Check that there are no people or objects in the
hazardous area of the lift.
• Afterwards, lift the vehicle to the desired working
height.
Ensure secure vehicle placement on
the carrier plate, otherwise there is a
danger of the vehicle dropping.
i See to it that the lifting arm blocks are ratcheted
in after the vehicle has been accepted.
Figure 4: Operating unit
OPI-POWER LIFT HF 3S 3000-4000-V3.2-DE-EN-FR-ES-IT
Main switch
Operating lever
Fig. similar