Using The Battery Charger To Charge The Battery - Invacare Stand Assist Reliant RPS350-1E Manuel D'utilisation

4.7.3 Using the Battery Charger to Charge the
Battery
This procedure only applies to the RPS350–1E.
Lift up on the handle A on the back of the battery B.
1.
Lift the battery up and out away from the control box C.
2.
CAUTION!
Mounting the battery improperly may cause injury or
damage.
– Make sure there is an audible click when mounting
battery on the battery charger to confirm proper
mounting.
1078985-G
3. Place the battery on the battery charger D as shown. Make sure
there is an audible click.
The charge LED will illuminate. When charging is
complete, charge LED will stop illuminating.
A battery needing to be fully recharged will take
approximately four hours.
4. Lift up on the handle on the back of the battery.
5. Lift the battery up and out away from the battery charger.
CAUTION!
Mounting the battery improperly may cause injury or
damage.
– Make sure there is an audible click when mounting
battery on the control box to confirm proper
mounting.
6. Reinstall the battery onto the control box as shown. Make sure
there is an audible click.
The battery mounts to the control box and battery charger
as shown.
Usage
23