Installing The Shifter Handle; Attaching The Battery Charger Mounting Bracket To The Wall - Invacare Stand Assist Reliant RPS350-1E Manuel D'utilisation

3.4 Installing the Shifter Handle

A Shifter Handle
1. Remove the shifter handle from the packaging carton.
2. Thread the shifter handle onto the male adapter on the base.
1078985-G
B Male Adapter in Base
3.5 Attaching the Battery Charger Mounting
Bracket to the Wall
Refer to your local regulations concerning proper mounting
procedures.
This procedure only applies to RPS350–1E models.
Place the battery charger with mounting bracket A on the wall
1.
at the desired position.
2. With a pencil, mark the middle hole B position.
3. Measure down 6½ inches (16.5 cm) from the pencil mark and
drill one mounting hole.
Install the bottom mounting screw C until there is an
4.
approximate 1/8-inch (3 mm) gap between the screw head and
the wall.
5. Install the battery charger with mounting bracket onto the
bottom mounting screw.
6. Drill the remaining two mounting holes.
Setup
15