EUFAB AMBER III Manuel De L'opérateur page 8

Bicycle rack „AMBER III" for trailer tow bar
CONTENTS
1. PROPER USE OF THE PRODUCT
2. SCOPE OF DELIVERY
3. SPECIFICATIONS
4. TOW BAR REQUIREMENTS
5. SAFETY NOTES/WARNINGS
6. MOUNTING THE BICYCLE RACK
7. MAINTENANCE
8. NOTES FOR ENVIRONMENTAL PROTECTION
9. CONTACT INFORMATION
WARNING
Read the operating instructions through carefully prior to initial use and observe all of the safety notes! Store original packaging,
proof of purchase as well as these instructions for future reference! Not observing such may lead to personal injury, damages to the
device or your property! Prior to initial use, check the contents of the packaging to ensure that they are in perfect condition and
complete!
1. PROPER USE OF THE PRODUCT
This bicycle rack is mounted to the trailer tow bar of a car and is designed for the transportation of up to three bicycles. Intended use also includes the observation of
all information provided in these mounting instructions, particularly of the safety instructions. Any other use is considered improper and can lead to property damage
or personal injury. EAL GmbH assumes no liability for damage resulting from improper use.
2. SCOPE OF DELIVERY
1 x Base frame
6 x Wheel rail halves
1 x Lamp mount set
1 x U-bracket
1 x Frame holder, short
1 x Frame holder, long
1 x Frame holder, wheel to wheel
3 x Plastic cover
3. SPECIFICATIONS
Weight: 16 kg
Payload: 34 kg at 50 kg supporting load
44 kg at 60 kg supporting load
59 kg at 75 kg supporting load
max. 60 kg at 90 kg supporting load
max. 60 kg at 100 kg supporting load
Electrical connection 13-pin
4. TOW BAR REQUIREMENTS
• The trailer tow bar must be approved in its construction.
• Ball and ball rod must have been forged in one piece.
• Only mount the bicycle rack to a tow bar of steel St52, grey cast iron GGG52 or higher quality.
• The D-value of the tow bar ball must be at least 7.6 kN
• Never mount the rack to a tow bar made of aluminium, other light metals or plastic.
Unsuitable ball rods made from GGG40 are produced by Westfalia for the following vehicles:
Manufacturer Test symbol
Westfalia F 4192
F 3830
F 4112
Observe the instructions from the tow bar manufacturer. If in doubt, ask your manufacturer directly whether their trailer tow bar is suitable.
Not suitable for trailer tow bars made from aluminium.
8
9 x Tensioning strap, short
1 x Tensioning strap, long
12 x Lock screw M6 x 50
12 x Washer 17.8 x 6.5 x 1.1
12 x Nut M6
1 x Cross-headed screw M5 x 12
1 x Washer 9.8 x 5.4 x 0.9
1 x Spring washer 8.4 x 5.5 x 1.5
Suitable for
Audi A4
Audi A6
Audi A8
2 x Cross-headed screw M5 x 35
2 x Spring washer 8.1 x 5.5 x 1.2
2 x Washer 9.7 x 5.3 x 0.9
2 x Lock screw M8 x 60
2 x Washer 15.8 x 8.5 x 1.1
2 x Knob nut M8
Cable tie
8
8
8
8
9
9
12
12
12