EUFAB AMBER III Manuel De L'opérateur page 10

Assembly
Two wheel rails form a pair. Place three pairs of wheel rails, with the plastic shells on the outside, so that they are parallel on the base frame and the drilled holes in
the rail match the holes in the base frame. Secure each wheel rail to the base frame with the lock screws M6 x 50, washers and self-tapping nuts M6.
Join the two halves of the lamp mount set together. This is made easier by the small
guide element which is already mounted on one side. Push the rails together and
secure the connection with the cross-headed screw (M5x12), spring washer and
washer.
Insert the cross-headed screws M5 x 35 with spring washers and washers, from
below, through the vertical drilled holes of the lamp mount. Insert the screws th-
rough the threaded holes on the underside at the end of the lamp mount. Tighten
the screws.
Make sure that the fog light is installed on the left side of the mount!
Step 2
Components
Assembly
Place the U-bracket on the U-bracket mount of the base frame. Secure the U-bracket with the supplied lock screws (M8 x 60), washers and knob nuts M8. The knob
nuts must be mounted on the inside (see photograph).
Caution: You must tighten both knob nuts very firmly to ensure that the U-bracket is flush against the U-bracket mount.
Step 3
Components
Mounting the frame holder
Undo the handle screw of the frame holder and rotate out fully. Open the cuff of the frame holder and place the inserts around
the U-bracket at a position suitable for your bicycle. Place the cuff around the inserts and push firmly together. Close the frame
holder using the handle screw (but do not tighten).
Mounting the license plate holder
Remove the screws from the lamp mount before installing the license plate holder and then mount the license plate holder.
The license plate holder must be at the same height as the lights.
10