Risk Of Injury - Abicor Binzel PP Plus 36D Mode D'emploi

PP Plus 36D/401D
8.2 Cleaning the wire guide
8.3 Torch neck
3 Replace wire feed roll (6) and secure it on the motor shaft using the
knurled screw (2)
4 Swing in the clamp clip (3) and close the housing cover (1).
1 Unscrew the cable assembly on the machine side and bring it into a
stretched position.
 See Fig. 3 on page EN-7
2 Unscrew the nut (6) and pull out the liner (8) or PA liner and replace it, if
necessary.
WARNING

Risk of injury

Serious injuries caused by parts swirling around.
• When cleaning the wire guide with compressed air, wear suitable
protective clothing, in particular safety goggles.
3 Clean wire conduit (3) from both sides with compressed air.
4 Slide adjusted liner or PA liner into wire conduit (3) and secure it with the
nut (6).
5 Connect cable assembly on the machine side to the wire feed unit.
In stretched condition of the cable assembly, a counter pressure must be
noticeable.
1 Remove gas nozzle.
2 Remove welding spatter and spray gas nozzle with ABICOR BINZEL
anti-spatter agent.
3 Check wear parts for visible damage and replace them, if required.
4 Replace neck liner or wire guide when worn or soiled.
5 Clean the separating point and grease O-rings with silicone-free sealing
grease.
8 Maintenance and cleaning
EN - 15