Ryobi RLM1956MEB Traduction Des Instructions Originales page 6

5. Height adjustment lever
6. Handle knob
7. Starter grip
8. Power lever
9. Rope guide knob
10.
11. Panel
13. Pins
14. Side discharge door
15.
16. Side discharge door opening
ASSEMBLY
UNPACKING
This product requires assembly.
Inspect the product carefully to make sure no breakage
or damage occurred during shipping.
If any parts are damaged or missing, please call your
Ryobi service centre for assistance.
WARNING
If any parts are damaged or missing do not operate this
product until the parts are replaced. Using a product
with damaged or missing parts could result in serious
personal injury.
WARNING
Do not attempt to modify the product or create
accessories not recommended for use with the product.
result in a hazardous condition leading to possible
serious personal injury.
WARNING
The lawnmower safety systems or features shall not be
tampered with or disabled.
WARNING
Never attach or adjust any accessory while the mower
is running. Failure to stop the engine may cause
serious personal injury.
WARNING
To prevent accidental starting that could cause serious
personal injury, always disconnect the engine spark
plug wire from the spark plug when assembling parts.
4
WARNING
Never operate the mower without the proper safety
devices in place and working. Never operate the mower
with damaged safety devices. Operation of this product
with damaged or missing parts could result in serious
personal injury.
INSTALLATION OF THE PANEL
1. Use a wrench and socket set (not provided) with the
bolts and nuts to secure the panel on the handle.
INSTALLATION
1. Place handles in correct operating position and tighten
handle knobs to secure.
NOTE: Do not pinch the cable.
Place starter rope in guide on handle.
3. Install grass catcher or mulching plug.
SETTING BLADE HEIGHT
When shipped, the wheels on the mower are set to a low-
adjust the cutting position to the height best suited for your
lawn. The average lawn should be between 38 mm to 50
mm during cool months and between 50 mm and 76 mm
during hot months.
To set the blade height:
To raise the blade height, grasp the height adjustment
lever and move it toward the back of the mower.
To lower the blade height, grasp the height adjustment
lever and move it toward the front of the mower.
INSTALLING SIDE DISCHARGE DEFLECTOR (FOR
SIDE DISCHARGE OPERATION)
NOTE:
install the grass catcher. The mulching plug should remain
installed.
1. Lift the side discharge door.
the underside of the door.
3.
mulch door hinge rod.
4.
OPERATION
FUEL AND REFUELLING
WARNING
English