Beurer BC 51 Mode D'emploi page 41

ding to the positioning indicator does not match the level of the heart, use your own judgement. You
can also start the measurement in these cases at any time by pressing the START/STOP button
Selecting the user
This device has 2 user memories with 120 memory spaces each in order that you can save measure-
ments from 2 different people separately from each other.
If multiple people are using the device, make sure that the relevant user is set before each measure-
ment.
To select the relevant user memory, press the memory button M1 (for user
memory ) when the device is switched off. Then confirm your selection by pressing the START/
STOP button .
Performing the blood pressure measurement
• Press the START/STOP button
play elements are briefly displayed.
• The blood pressure monitor will begin the measurement automatically after ap-
prox. 3 seconds.
• The cuff inflates automatically while the actual measuring process starts. As
soon as a pulse is found, the pulse symbol
You can cancel the measurement at any time by pressing the START/STOP
button
• The remaining air is released quickly once the measurement is complete.
• Systolic pressure, diastolic pressure and pulse measurements are displayed.
• appears if the measurement could not be performed properly. In this
case, please read the section"What if there are problems?".
• Press the START/STOP button
measurement is then stored in the selected user memory.
to start the blood pressure monitor. All dis-
is displayed.
to switch off the blood pressure monitor. The
41
.
) or M2 (for user