Initial Operation; Switching The Mixer On/Off; Selecting An Input - MC Crypt DJ-60 Notice D'emploi

8. Initial operation

Do not put the device into operation until your have familiarised yourself with the functions and
these operating instructions. Check again that all connections are correct.
a) Switching the mixer on and off
Failure to observe the order described in the following when switching the mixer on and off
could damage the loudspeakers or the amplifier.
Switching on
• Make sure that all channel faders (12) are set to minimum volume (channel fader pulled right back to the lowest
point).
• Switch on the output devices that are connected to the mixer first.
• Turn the mixing desk on with the POWER switch (16).
• Switch on the connected amplifier and the recording device (connected to the REC socket (20)). The mixer is now
ready for operation.
Switching off
• To switch off the mixer, first turn the volume on the mixer and then on the amplifier down to the minimum setting.
• Switch off the amplifier.
• Next, switch off the mixer using the POWER switch (16) and then the reproduction devices (record player, CD
player etc.).
• If you do not require the mixer for a longer period, unplug the power supply unit from the socket.
b) Selecting an input
Reduce the volume to the minimum setting using the relevant channel fader (12) before
actuating an input selection switch (1). Due to the different levels of the output sources, sudden,
excessive volume could occur when switching between the inputs.
• Use the input selection switches (1) to select the desired inputs.
39