Connection; Connecting The Inputs - MC Crypt DJ-60 Notice D'emploi

7. Connection

Before connecting, disconnect the mixer and all other devices which are to be connected to the
mixer from the mains voltage (unplug power unit or mains plug from the socket).
When connecting the cinch inputs and outputs, use only shielded cinch cables suitable for this
purpose. For connecting the microphone input, please only use a suitable microphone cable.
Using incorrect cables may lead to interference.
To avoid distortion or mismatching which may damage the mixer, only connect output devices
with a cinch output to the cinch inputs of the mixer. Only devices with cinch inputs may be
connected to the mixer's cinch outputs.
Also observe the connection values in the „Technical Data" chapter.
The following applies for all cinch connections:
• The white cinch jack on the mixing desk is the jack for the left channel.
• The red cinch jack on the mixing desk is the jack for the right channel.
a) Connecting the inputs
LN-2 and LN-4 inputs
There are two stereo cinch inputs available to which you can connect your reproduction devices, e.g. radio, CD player
or MP3 player. These inputs are suitable for connecting audio devices with line level.
The inputs are not suitable for record players.
LN-1/PH-1 and LN-3/PH-2 inputs
These inputs are variable inputs which can be influenced by their respective selection switches (21 and 23).
Depending on the switch position, these inputs can be used to connect a record player or a CD player (or similar line
device).
Before connecting, check the position of the respective selection switch (21 or 23). Set the
switch to the correct position. Before switching over, always switch off the mixer at the POWER
switch (16).
LN switch position:
PH switch position:
36
A device with LINE level, e.g. CD player, MP3 player or radio, can be connected to the
appropriate input.
Record player with a magnetic system (this system is used by almost all DJ record
players) can be connected to the appropriate input.