Ryobi RLM4614 Traduction Des Instructions Originales page 13

TROUBLESHOOTING
Problem
Handle not in correct Handle positioned incorrectly.
position.
Handle knobs not tightened.
Mower does not No petrol.
start.
Engine is fl ooded.
Starter rope is harder to pull now than
when it was new.
Mower hard to push. High grass, rear of mower housing
and blade dragging in heavy grass, or
cutting height too low.
Wheel assembly needs cleaning.
Mower vibrating at Blade is unbalanced.
higher speed.
Bent motor shaft.
Grass catcher not Discharge chute blocked
filling with grass, but
grass is being cut
from lawn.
Possible cause Solution
Check to be sure that lower part of handle is pushed fully
back and snapped into proper position.
Tighten handle knobs.
Fill mower with petrol. If mower still does not start, contact
a servicing dealer.
Wait 15 minutes, then try starting mower again. Do not
prime before attempting to start.
Contact a servicing dealer.
Raise cutting height.
Clean wheel assembly. See Drive Gear Maintenance.
Replace blade.
Stop the engine, disconnect the spark plug wire from the
spark plug, and inspect for damage. Have repaired by an
authorized service center before restarting.
Stop engine, wait for it to stop, remove spark plug. Remove
grass catcher and lift discharge chute cover. Beware
of sharp blade, avoid contact. Remove debris from the
discharge chute.
EN
English
FR
DE
ES
IT
NL
PT
DA
SV
FI
NO
RU
PL
CS
HU
RO
LV
LT
ET
HR
SL
SK
BG
UK
11