Selection And Qualification Of Personnel - Basic Duties; Product-Specific Hazards; Removal Of Electrode/Sensor - Mettler Toledo InFlow 76X Instructions D'utilisation

InFlow 76X
InFlow 76X
52 403 711
2.8.3 Selection and qualification of personnel – basic duties
– Work on or with the flow-through housings may only be carried out by authorized and
appropriately trained or instructed personnel. The personnel must have read this instruction
manual in advance.
– Clear responsibilities must be established for the personnel entrusted with operation, service,
repair, etc. of the flow-through housings.
– It must be ensured that only specifically assigned personnel may operate the flow-through
housings.
DANGER
Incorrect manipulation or operation of the flow-through housings or non-observance of safety
regulations can lead to malfunction of the flow-through housing and to the escape of process
medium, thus presenting a potential hazard to the environment, personnel and material.
2.9

Product-specific hazards

2.9.1 Removal of electrode/sensor

DANGER
The electrode or sensor must be removed only after the piping/vessel has been depressurized
and emptied. Otherwise, the removed electrode/sensor may cause the process medium to
escape thus presenting a severe danger to persons, material and the environment. Any toxic
or aggressive medium may cause severe poisoning or causticization.
NOTICE
Any broken sensor or defective/cut O-ring must be replaced without delay.
DANGER
Broken sensors prevent accurate measurings and thus adversely affect process safety.
© 04/17 Mettler-Toledo GmbH, CH-8606 Greifensee
13
Printed in Switzerland